Motorola Starline SG 2000 - Table 3-1 AC Fuses

3-4 Bench Setup
SG 2000 Installation and Operation Manual
Table 3-1 identifies and describes the ac fuse options:
Table 3-1
AC fuses
Fuse Function Rating Type
F1
This fuse delivers ac power to all ports. It is always required
except when power from the ac input (port 2) must be
blocked at this location.
20 A,
32 Vdc
Auto,
plug-in, fast
blow
F2
This fuse passes ac power to/from port 1. 20 A,
32 Vdc
Auto,
plug-in, fast
blow
F3
This fuse passes ac to/from port
IN.20A,
32 Vdc
Auto,
plug-in, fast
blow
F4
This fuse is always required for the dc power supply. 10 A,
32 Vdc
Auto,
plug-in, fast
blow
F5
This fuse passes ac to/from port
OUT.20A,
32 Vdc
Auto,
plug-in, fast
blow
F6
This fuse passes ac to/from port 3. 20 A,
32 Vdc
Auto,
plug-in, fast
blow
F7
This jumper ties two sections of the ac power bus together
thus delivering ac power to both sides of the node. It should
be removed only when dual power supplies are fed from
separate ac sources.
Jumper Auto,
plug-in,
shunt
F8
The 5V circuit includes Fuse F8 which protects the lid and
RF board under short-circuit conditions in conjunction with
redundant power supplies.
5A,32Vdc Auto,
plug-in, fast
blow
F9
The 24V circuit includes Fuse F9 that protects the lid and
RF board under short-circuit conditions in conjunction with
redundant power supplies.
10 A,
32 Vdc
Auto,
plug-in, fast
blow
CAUTION!
Voltages up to 90 Vac are accessible. To avoid shock hazard, confirm that no power is
applied to the node before removing cover or replacing fuses.