4-4 Installation
SG 2000 Installation and Operation Manual
Figure 4-3
Mounting bracket-rear and side views
34 OUT
12IN
6
3
7 8
2
1
4
5
To mount the housing to the strand wire:
1 Attach the bracket to the housing using the two 5/16 × 18 bolts.
2 Loosen the 3/8 × 16 strand clamp bolt located on each mounting bracket.
3 Engage the strand in the housing strand clamps. Do not tighten the hex-head bolts at this time.
This enables the clamps to slide along the strand wire until the housing is finally positioned with
respect to the cables.
4 Re-install all modules and electronic components that were removed before the housing was
installed.
Connections to the housing are made using standard KS-type housing port entry connectors. Pin-type
connectors with a nominal center conductor diameter of 0.067 inches are required. Measuring from
the seating plane of the connector, the center conductor pin length must be 1.50 inches minimum and
1.65 inches maximum.
To Next Page
Loading...
