Motorola Starline SG 2000 - Figure 4-5 Housing Lid and Fiber Spool Tray; Figure 4-6 Fiber Spool Tray

4-6 Installation
SG 2000 Installation and Operation Manual
3
Carefully dress the excess fiber into the ramp of the fiber spool tray. Wrap the fiber around the
spooling cylinder one to two times depending on the length of the fiber. The diameter of the
spool tray is matched to the bend radius of the fiber. Also ensure that the fiber is routed under the
retaining flanges and through the pegs of the fiber tray for proper routing to the optics modules.
Figures 4-5 and 4-6 illustrate the housing lid and fiber spool tray:
Figure 4-5
Housing lid and fiber spool tray
Figure 4-6
Fiber spool tray
Fiber routed to optics modules
through fiber tray pegs