Installation 4-7
SG 2000 Installation and Operation Manual
4
Connect each fiber by removing the protective boot from the fiber connector, cleaning the
connector with pure isopropyl alcohol (99%) using a lint-free wipe, and drying it with filtered
compressed air. After cleaning the fiber, insert it into the appropriate receiver or transmitter
module.
5 Position the fiber service cable in the compression fitting to provide some slack in the fibers
inside the housing. Tighten the compression nut until it bottoms out. Finally, tighten the water
seal nut until there is no gap between it and the compression nut.
6 Close the housing and use a torque wrench to sequentially and progressively tighten the housing
bolts to a final torque of 12 ft-lbs. in the sequence stamped on the housing lid as illustrated in
Figure 1-1.
To Next Page
Loading...
