6881039B25 January 08, 2002 23
Level III Service Manual Disassembly
Removing and Replacing the Transceiver Board Assembly
1. Remove the battery cover, battery, SIM, rear housing cover, and rear trans-
ceiver housing as described in the procedures.
2. Lift the end of the transceiver board out of the front transceiver housing as
shown in Figure 10.
3. Gently slide the bottom end of the transceiver board out of the front transceiver
housing. The transceiver board should separate easily from the front housing.
4. Lift the transceiver board assembly completely away from the rear housing.
5. To replace, align the bottom end of the transceiver board assembly with the
rear housing and slide into place.
6. Replace the rear transceiver housing, rear housing cover, battery, SIM, and
battery cover as described in the procedures.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
011102-o
Figure 10. Removing the transceiver board assembly
TRANSCEIVER BOARD
To Next Page
Loading...
