26 January 08, 2002 6881039B25
Disassembly
Removing and Replacing the Keypad
1. Remove the battery cover, battery, SIM, rear housing cover, rear transceiver
housing, and transceiver board as described in the procedures.
2. Using the tweezers, lift the keypad away from the front transceiver housing
as shown in Figure 13.
3. To replace, insert the keypad into the front housing. Ensure the keys align
properly with the openings and the keypad is fully seated in the front housing
4. Replace the transceiver board, rear transceiver housing, rear housing cover,
SIM, battery, and battery cover as described in the procedures.
Removing and Replacing the Keypad PCB Assembly
1. Remove the battery cover, battery, SIM, rear housing cover, rear transceiver
housing, and transceiver board as described in the procedures.
011103o
Figure 13. Removing the keypad
KEYPAD
PLASTIC TWEEZERS
FRONT HOUSING
To Next Page
Loading...
