28 January 08, 2002 6881039B25
Disassembly
Removing and Replacing the Ring Bezel Assembly
1. Remove the battery cover, battery, SIM, and transceiver board assembly as
described in the procedures.
2. Using the flat end of the disassembly tool, turn the ring bezel assembly a few
millimeters in a counter-clockwise direction as shown in Figure 15.
3. Lift the ring bezel from the front blade housing.
4. To replace, align the ring bezel assembly such that the middle key is just to
the left of the volume up/down key as shown in Figure 15.
5. Using the flat end of the disassembly tool, turn the ring bezel assembly slightly
in a clockwise motion until the ring bezel locks into place onto the front blade
housing.
6. Replace the transceiver board assembly, SIM, battery, and battery cover as
described in the procedures.
G
The ring bezel is reusable. Do not bend the catches permanently.
011105-o
Figure 15. Removing the ring bezel assembly
FRONT
BLADE
HOUSING
RING BEZEL
DISSASSEMBLY TOOL
To Next Page
Loading...
