32 January 08, 2002 6881039B25
Disassembly
Removing and Replacing the Microphone
1. Remove the battery cover, battery, rear housing cover, rear transceiver housing
transceiver board, and keypad PCB assembly as described in the procedures.
2. Using the flat end of the disassembly tool, carefully press the microphone out
of the keypad assembly PCB as shown in Figure 17. The microphone should
come away easily.
3. To replace, align the microphone with the hole on the keypad PCB assembly
and gently press straight down until fully seated.
4. Replace the keypad PCB assembly transceiver board assembly, front cover,
battery, and battery cover as described in the procedures.
011208-o
Figure 17. Removing the microphone
MICROPHONE
KEYPAD
PCB
ASSEMBLY
To Next Page
Loading...
