8 Settings via the MICT
48 Rev. 08/2018
3. Enter the PIN for the desired level.
4. Confirm the input with OK.
▸ You are now logged into the corresponding level and can execute all functions that are
allocated to this operating level without having to log in again.
After completing the log-in, you can log out again as follows:
Device -> Access Control -> Logout
8.7.3 Changing the PIN
To change the PIN for a specific operating level, proceed as follows:
1. Open the input dialog via Device -> Access Control -> Change PIN.
2. First select the level for which you wish to change the PIN.
3. Enter the current PIN for the desired level.
4. Enter the new PIN in the two subsequent fields.
5. Confirm the input with OK.
▸ The PIN for this operating level has now been changed.
8.7.4 Reset all PINs
To reset all PINs, proceed as follows:
1. Open the input dialog via Device -> Access Control -> Reset all PINs.
2. If you are not yet logged into the Master (level 3) level, you will be prompted to log in with
the relevant PIN.
3. Confirm the input with OK.
4. To reset all PINs, you will be prompted again to enter the PIN for the level Master (Level 3).
5. Confirm the input with OK.
▸ All PINs are now reset to the value 0000.
To reset all PINs, you need the PIN for the level Master (level 3). To be able to unlock a system in
case of emergency that was locked in this way, you have the following option:
1. In the menu bar, select the entry Device -> Access Control -> Get reset all PINs request key to
open a window with the same name.
2. Send the request key with the serial number to your service contact person at MOTORTECH
(refer to Customer Service Information on page 79). This key is valid only for the respective
controller and only for a certain amount of time.
▸ Your information will be verified, and you will receive an authorization key from your
contact person.
To Next Page