8 Settings via the MICT
Rev. 08/2018 49
3. From the menu bar, select the entry Device -> Access Control -> Set reset all PINs
authorization key to open a window with this name.
4. Enter the authorization key received in the input field.
5. Confirm the input with OK.
▸ If the input was correct, all PINs are reset to the default value 0000.
8.8 Working with Configurations
To ensure that the VariStep3 stepper motor driver interprets incoming data correctly and
converts them to the desired control signals, it requires information on the device connected
and the master control connected. This information is stored in a configuration file on the
stepper motor driver.
You need the MICT for the following tasks:
– Creating configuration files
– Opening configuration files from a storage device
– Processing configuration files
– Saving configuration files on a storage device
– Downloading configuration files to a VariStep3 stepper motor driver
– Uploading configuration files from a stepper motor driver
– Displaying current and saved runtime data
To Next Page