8 Settings via the MICT
70 Rev. 08/2018
CPU Load
Current capacity utilization of the processor.
Supply voltage
Current supply voltage of stepper motor driver.
Current Temp.
Current temperature of board.
Max Temp
Maximum reached temperature of the board since the stepper motor driver was switched on the
last time.
Min Temp
Minimum reached temperature of the board since the stepper motor driver was switched on the
last time.
Max. Step Loss
Internal diagnosis parameters associated with the control of the stepper motor. The maximum
step losses that have occurred since the last switch-on are displayed. If the step losses are too
high, this will cause an error message.
To Next Page