Movacolor MC18-Micro - Appendix A: Technical Specifications

20
MC18-Micro manual
APPENDIX A: MC18-Micro Technical Specifications
Controls:
Speed: Manual setting from 0,1 to 200 RPM max, in increments of 0,1 RPM.
Time: Manual settings from 0,1 to 999,9 sec in increments of 0,1 sec.
Voltage settings of tacho-voltage: auto-detect.
Integrated hopper loader controller.
Monitoring/System Information/External communication
Man/Machine interface: Keypad controller. 4-piece 7 segments LED at front display.
External Communication: None.
Alarm: LED Indication + Internal beeper, 1x external alarm output.
Specifications/Standards & Directives/ Technical data:
Power supply: Operating power from 80 VAC to 260 VAC, 50 and 60 Hz
by integrated automatic voltage selector.
Power consumption: 80 Watt maximum.
Stepper motor: (1,8degr/step) max 2 Amp at 40 Volt.
Operating Temperature: -20 to +70 degrees Celsius.
Input signal(s):
Injection molding: Start/Stop trigger input, potential free or 18-24VDC*
Input for level sensor.
Extrusion: Start/Stop trigger input, potential free or 18-24VDC*
Tacho input 0..30VDC
Input for level sensor.
* Note potential contact
Guaranteed OFF: 0-8VDC.
Guaranteed ON: 18-30VDC.
Output(s):
 Stepper motor max. output 2A (40VDC).
 Solid state 24VDC/0.5 A output for valve hopper loader.
 Solid state 24VDC/0.5 A output for external alarm.
 Maximum total output power: 12 Watt (Valve output + alarm output).
Standard Directives: Protection class: IP-50.
Safety
 In case of overload due to short-circuit or in correct connection, the power supply automatically shuts down;
 Opto-insulated start input for connection to production machine.
Machine connection flange:
Standard flange MCBasic Neckpiece.
Optional parts
 Neckpiece type NST40 with cleaning opening and inlet/outlet Ø50mm/45mm, steel epoxy coated;
 Neckpiece type NST90 with cleaning opening and inlet/outlet Ø50mm/90mm, steel epoxy coated;
 Water-cooled flange BH(A) inlet/outlet 50mm/50mm stainless steel ANSI 304;
 Water-cooled flange PHA inlet/outlet 100mm/100mm;
 Hopper loader type ME-Micro;
 Mixers;
 Capacity sensor (Hopper empty detection / filling alarm);
 External Alarm Flash light;
 External Alarm Siren.