Moxa Technologies EDS-2010-ML Series User Manual

- 7 -
Suggested Installation Method
STEP 1:
Detach the metal DIN-rail mounting kit from the back panel and attach
it to the side panel (mold side) in either the horizontal or vertical
direction as indicated in the figure below.
STEP 2:
Insert the upper lip of the DIN
-rail kit
into the mounting rail.
STEP 3:
Press the device towards the mounting
rail until it snaps into place
.
Suggested Removal Method
STEP 1:
Pull down the latch
on the DIN-rail kit
with a screwdriver.
STEP 2:
Slightly pull the device forward and lift
up to remove it from the mounting rail.
NOTE
Screws that are used to fix the DIN-rail kit on the EDS should
be securely fastened before mounting on the mounting
rail.
Please make sure that if you remove the DIN
-rail, it must be
securely fastened when it is reattached.

Moxa Technologies EDS-2010-ML Series Specifications

General

Brand	Moxa Technologies
Model	EDS-2010-ML Series
Category	Switch
Language	English