- 8 -
Wall Mounting (optional)
For some applications, you will find it convenient to mount EDS on the
wall, as illustrated below.
STEP 1:
Remove the aluminum DIN-Rail attachment plate from EDS’s rear
panel, and then attach the wall mount plates, as shown in the diagram
below.
on the wall requires 4 screws. Use the
switch, with wall mount plates attached, as a guide
to mark the correct locations of the 4 screws. The
heads of the screws should be less than 6.0 mm in
diameter, and the shafts should be less than 3.5 mm
in diameter, as shown in the figure at the right.
Before tightening screws into the wall, make sure the screw
head and shank size are suitable by inserting th
e screw into
-shaped apertures of the Wall Mounting
Do not screw the screws in all the way—leave about 2 mm to allow
room for sliding the wall mount panel between the wall and the screws.
Once the screws are fixed in the
wall, insert the four screw heads
through the large parts of the
keyhole
-shaped apertures, and
hen slide EDS downwards, as
indicated. Tighten the four
screws for added stability.
External metal parts are hot. Take necessary precautions if
it is necessary to touch.
To Next Page
Loading...
Need help?
General
