Moxa Technologies MGate 5111 - Pin Assignments; Power Input and Relay Output Pinouts

MGate 5111 Getting Started
2-6
SW MODBUS
1 2 3
Pull-up resistor Pull-down resistor Terminator
ON 1 kΩ 1 kΩ 120 Ω
OFF 150 kΩ (default) 150 kΩ (default) – (default)
Pin Assignments
The MGate 5111 uses DB9 serial ports to connect to Modbus RTU or ASCII devices. Each port supports three
serial interfaces that is selected by software: RS-232, RS-422, and RS-485 (both 2 and 4-wire).
RJ45 (Ethernet, Console)
Pin Ethernet Console (RS-232)
1 Tx+ DSR
2 Tx- RTS
3 Rx+ GND
4 – TxD
5 – RxD
6 Rx- DCD
7 – CTS
8 – DTR
Male DB9 (Serial port)
Pin RS-232 RS-422/RS-485-4W RS-485-2W
1 DCD TxD-(A) –
2 RxD TxD+(B) –
3 TxD RxD+(B) Data+(B)
4 DTR RxD-(A) Data-(A)
5* GND GND GND
6 DSR – –
7 RTS – –
8 CTS – –
9
–
–
–
*Signal ground
PROFIBUS Port (Female DB9)
Pin CAN
1 N.C.
2 N.C.
3 PROFIBUS D+
4 RTS
5 Signal common
6 5V
7 N.C.
8 PROFIBUS D-
9 N.C.
Power Input and Relay Output Pinouts