Step 2: Select Protocol
Then, you have to select the protocols used on your devices that are connected through the MGate. After
selection, the MGate will automatically change its role to the correct one. For example, if the device is set as a
Modbus TCP Server, the MGate will then automatically configure as a Modbus TCP Client by itself. Regarding
protocol configuration, please refer to chapter 4.
Example of Role 1 and Role 2:
After finishing the device protocol selection, Role 1 and Role 2 of the MGate will be set accordingly. You will
need to configure the details on each side with the following steps. Here is an example of Role 1 as a PROFIBUS
Master, and Role 2 as a Modbus TCP Server device.
To Next Page
Loading...
