Moxa Technologies MGate 5111 - 2 Getting Started

2
2. Getting Started
This chapter provides basic instructions for installing the MGate 5111.
The following topics are covered in this chapter:

Connecting the Power

Connecting PROFIBUS Devices

Connecting Serial Devices

Connecting to a Host or the Network

Installing the Software (Optional)

Wiring Requirements

LED Indicators

Dimensions

Pull Up/Down Resistors for RS-485 (Modbus)

Pin Assignments

Power Input and Relay Output Pinouts

Hardware Installation

Specifications

microSD Card
 Backing Up a Configuration
 Configuring an MGate (Mass deployment/Replacement)
 microSD card Write Failure

Quick Setup
 Step 1: System Setting
 Step 2: Select Protocol
 Step 3: PROFIBUS Slave Settings
 Step 4: Modbus TCP Settings
 Step 5: Finish