Moxa Technologies MGate 5111 - Protocol Settings

MGate 5111 Web Console Configuration
4-5
Protocol Settings
The MGate 5111 supports PROFIBUS, Modbus RTU/ASCII, Modbus TCP, EtherNet/IP and PROFINET protocols.
Each role is determined by your device's settings. Modbus TCP (Client/Server), Modbus RTU/ASCII
(Master/Slave), EtherNet/IP (Adapter), and PROFINET (IO Device) can be selected.
The setting of each protocol is described as follows:
1. PROFIBUS Slave
Slave Settings
Parameter Value Default Description
Slave address PROFIBUS address
0~99 (addresses 100 to
125 supported by SW)
Depends on the
rotary switch
Before any communication, you
must assign a slave ID to the
PROFIBUS slave. If you would
like to assign an address
between 0-99, you need to
change the rotary switch to the
desired address. If you would
like to assign an address which
is over 99, you must set it via
web console.
PROFIBUS I/O Table