Auto Warning Settings
Auto Warning is triggered by different events. When a checked trigger condition occurs, the MGate can send
e-mail alerts, SNMP Trap messages, or open/close the circuit of the relay output and trigger the Fault LED to
start blinking. To enable an e-mail alert, configure the e-mail address on the E-mail Alert page. Likewise, to
enable SNMP Trap alerts, configure SNMP trap server on the SNMP Trap page.
E-mail Alert Settings
Parameters Description
Mail server The mail server’s domain name or IP address.
User name This field is for your mail server’s user name, if required.
Password This field is for your mail server’s password, if required.
From e-mail address This is the e-mail address from which automatic e-mail warnings will be sent.
To e-mail address 1 to 4 This is the e-mail address or addresses to which the automatic e-mail warnings will
To Next Page
Loading...
