Moxa Technologies MGate 5111 - Hardware Installation; Specifications; Ethernet Interface

MGate 5111 Getting Started
2-7
V2+ V2-
V1+ V1-
DC Power Input 2 DC Power Input 2 N.O. Common N.C. DC Power Input 1 DC Power Input 1
Hardware Installation
The MGate 5111 is designed to be attached to a DIN rail or mounted on a wall. For DIN-rail mounting, push
down the spring and properly attach it to the DIN rail until it "snaps" into place. For wall mounting, install the
wall-mount kit (optional) first and then mount the device to the wall. The following figure illustrates the two
mounting options:
Specifications
Industrial Protocols
Protocols:
PROFIBUS, Modbus RTU/ASCII/TCP, PROFINET, EtherNet/IP
Protocol Conversion:
• Modbus RTU/ASCII (Master/Slave) to PROFIBUS slave
• Modbus TCP (Client/Server) to PROFIBUS slave
• EtherNet/IP (Adapter) to PROFIBUS slave
• PROFINET (IO Device) to PROFIBUS slave
Ethernet Interface
Protocols:
Modbus TCP (Client/Server), PROFINET (IO device),
EtherNet/IP (Adapter)
Number of Ports:
2 (1 IP address, supports Ethernet cascading)
Speed:
10/100 Mbps, Auto MDI/MDIX
Connector:
8-pin RJ45
Magnetic Isolation Protection:
1.5 kV (built-in)
PROFIBUS Interface
Protocol:
PROFIBUS DP-V0 Slave
Number of Ports:
1
Connector:
DB9 Female
Data Rate:
9600 bps to 12 Mbps