NPort 6000 Series Software Installation/Configuration
Configure the mapped COM ports
For Real COM Mode/Reverse Real COM Mode, to reconfigure the settings for a particular serial port on the NPort
6000, select the row corresponding to the desired port and then click the Setting icon.
1. On the Basic Setting window, use the COM Number drop-down list to select a COM number to be
assigned to the NPort 6000’s serial port that is being configured. Select the Auto Enumerating COM
Number for Selected Ports option to automatically assign available COM numbers in sequence to
selected serial ports. Note that ports that are “in use” will be labeled accordingly.
To Next Page
Loading...
Need help?
General
