EasyManua.ls Logo

mr. steam MS-SUPER 2E - eTEMPO Controls Installation; eTEMPO Control Box Contents and Overview; Before Installing eTEMPO Control

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
mr
.
steam
®
steamtherapy
®
eTempo
®
Controls
_________________________________________________________________________
eTEMPO
®
CONTROLS
Dimensional Information for the Round
and Square eTempo
®
and eTempo/Plus
®
BOX CONTENTS:
• eT EMPO or eTEMPO/PLUS Control
• Control Cable (30 ft.)
• Steam head
• Tube of Silicone Sealant
• Owner’s Manual
Before Installing
Turn power to the steam generator OFF before connecting the control to the
generator. Failure to turn the power off will result in an inoperable control.
Do not use any eTEMPO/Plus, eTEMPO or STEAM
GENIE
™
controls without reading and understanding the Mr.Steam steam
generator Installation and Operation Manual (PN 101289 Revision number
10.0/08 or higher). Failure to read and understand these instructions may
result in an inoperative or hazardous installation.
A peel and stick warning is provided with the Mr.Steam steam generator
Installation and Operation Manual. This label is to be applied to the wall of
the installed shower or steam enclosure.
Install the eTEMPO or eTEMPO/Plus controls according to installation
instructions. Failure to install according to instructions will result in an
inoperative control or hazardous overheating or inadequate heating of the
steam room.
If an eTEMPO or eTEMPO/Plus control is installed outside the steam room a
Remote Temperature Probe (PN MSTS) must be installed inside the steam
room per installation instructions supplied with the Remote Temperature
Probe. Failure to install according to instructions will result in an inopera-
tive control and overheating of the steam room.
Do not route eTEMPO/Plus, eTEMPO or STEAM GENIE
control wiring inside conduit together with power lines or close to hot water
or steam piping. Doing so may result in an inoperative or hazardous installation.
Do not alter or modify eTEMPO/Plus, eTEMPO or STEAM GENIE controls.
Doing so may result in an inoperative or hazardous installation.
IMPORTANT NOTES:
• Turn power to the steam generator OFF before
connecting the control to the
generator.
Failure to turn the power off will result in an inoperable control.
• Do not operate eTEMPO/Plus, eTEMPO or STEAM GENIE controls with other than a
Mr.Steam eTEMPO compatible steam generator. Mr.Steam residential steam generators
with serial numbers lower than 900000, or any other brand of steam generator are not to
be operated with eTEMPO controls. Doing so may result in an inoperative installation.
• This document contains important safety, operation and maintenance information.
Leave this document with the homeowner. Do not discard this document.
• Discontinue use of the steam generator or control if the steam generator is damaged 0or
otherwise not functioning properly. Doing so may result in an inoperative or hazardous
installation
!
CAUTION
!
WARNING
17
installer