What to do if Flair cannot connect to MRMC Control Unit RT-14?
If Flair fails to connect to the RT-14 and this is indicated in the Flair window, ensure that the RT-14's IP address ends with .234 and verify that the PC running the Flair motion control software and the RT-14 are connected to the same network.
Essential safety guidelines for using the RT-14 equipment.
Instructions on connecting the RT-14 to power and other devices.
Guidelines for maintaining and handling the RT-14 unit.
Recommended placement for the RT-14 unit.
Information regarding the product's proprietary rights.
General introduction to the RT-14 and its purpose.
Detailed steps and diagram for connecting cables.
Illustrates a typical setup with the RT-14 and connected equipment.
Common issues, their causes, and recommended solutions.
How to manage network (LAN) addresses within Flair software.
An overview and identification of the RT-14 front panel components.
Explanation of the status LEDs on the RT-14 front panel.
Description of the power switch functionality on the RT-14.
Summary of rear panel connectors and their purposes.
Detailed pin assignments for each connector on the rear panel.
Details on the Input/Output formats supported by the RT-14.
Information on the mimic input functionality and diagrams.
Specific wiring diagram for the E-stop functionality for Bolt.
General| Category | Control Unit |
|---|---|
| Manufacturer | MRMC |
| Model | RT-14 |
| Power Consumption | 10W |
| Protection Class | IP20 |
| Operating Temperature | -10°C to +50°C |
To Next Page