MSA altair 4 - Page 30

OPERATION MSA
30
ALTAIR 4 - Operating Manual
3.4.1 Sensor Setup
Each sensor can be turned ON or OFF.
For more information, see the flow charts in Section 7.6.
COMB/EX
O2
H2S
CO
Figure 3-2 Sensor Setup
(1) To bypass this setup, press the
[
]
or
[ ]
button; otherwise, continue
as follows.
(2) Press the
[
]
button to enter the submenu.
(3) Use the
[
]
or
[ ]
button to change the option and confirm with the
[
]
button.
(4) Repeat this procedure for all other sensors.
(5) After setting the last sensor, continue to Calibration Setup.