Ipv6 PXE Support [Enabled]
When “Enabled”, the system UEFI network stack will support Ipv6 protocol. This
item will appear when “Network Stack” is enabled.
[Enabled] Enables the Ipv6 PXE boot support.
[Disabled] Disables the Ipv6 PXE boot support.
SATA Mode [AHCI Mode]
Sets the operation mode of the onboard 1st SATA controller.
[IDE Mode] Specify the IDE mode for SATA storage devices.
[AHCI Mode] Specify the AHCI mode for SATA storage devices. AHCI (Advanced
the speed and performance of SATA storage device, such as Native
Command Queuing (NCQ) and hot-plugging.
[RAID Mode] Enables RAID function for SATA storage devices.
sSATA Mode [AHCI Mode]
Sets the operation mode of the onboard 2nd SATA controller.
[IDE Mode] Specify the IDE mode for SATA storage devices.
[AHCI Mode] Specify the AHCI mode for SATA storage devices. AHCI (Advanced
the speed and performance of SATA storage device, such as Native
Command Queuing (NCQ) and hot-plugging.
SATAX Hot Plug [Disabled]
Allows user to enable or disable the SATA hot plug support. This item will appear
when the “SATA Mode” set to [AHCI].
[Enabled] Enables hot plug support for the SATA ports.
[Disabled] Disables hot plug support for the SATA ports.
HD Audio Controller [Enabled]
HPET [Enabled]
Enables or disables the HPET (High Precision Event Timers) support.
Sets the onboard USB controller and device function. Press <Enter> to enter the sub-
menu.
USB Controller [Enabled]
Enables or disables all USB controller.
XHCI Hand-off [Enabled]
EHCI Hand-off [Enabled]
To Next Page
Loading...
