Introduction
9
Changing the oil
The oil change interval is every 100 hrs.
NOTE: The first oil change should be preformed at 8
hours.
NOTE: The oil filter should be replaced when the oil is
changed.
To change the oil:
1. Remove the cap from the oil drain. See Figure 1.5.
2. Remove the dipstick.
3. Slide a piece of 1/2” hose onto the drain.
See Figure 1.6.
4. Route the other end of the hose into an approved oil
drain pan.
5. Turn the oil drain a quarter turn counter-clockwise to
unlock it, then pull out 3/8” (9.5 mm) to open the
valve.
6. After all of the oil has been drained, close the oil drain
by pushing it in and turning it back a quarter turn.
7. Remove the drain hose.
8. Place the cap back on the oil drain.
9. Fill engine with 57 oz (1.7 L) of SAE 10W-30 oil with
a SM API rating or better.
NOTE: Refer to the oil chart to determine the proper
weight of oil to use.
10. Check the dip stick to verify that the oil is at the
proper level before returning to service.
Figure 1.5
Oil drain
Figure 1.6
1/2” hose
6$(
6$(
6$(:6$(:
6$(:
)
) ) ) ) ) )
&
&
&
& &
&
&
2LO&KDUW
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
