P90 Series Vertical Shaft Engines
54
6. Inspect the oil drain-back port. Make sure it will
allow oil to drain back into the engine.
See Figure 5.10.
7. Reassemble the PCV valve.
8. Tighten the cover bolts to a torque of 53 - 71 in lbs
(6 - 8Nm).
9. Inspect the PCV tubing for cracks, brittleness or
signs of leaking. Replace the PCV tube if any are
found.
See Figure 5.11.
10. Re-assemble the engine by following the above
steps in reverse order.
11. Test run the engine before returning to service.
Figure 5.10
Oil drain port
Figure 5.11
PCV tubing
PCV
chamber
cover
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
