Display text Meaning Task
SS Security Shut‐
down
Safety system has tripped a shutdown Determine cause of shutdown and rec‐
tify.
SS T-Coolant (ECU) Safety system detects excessive cool‐
ant temperature
Reduce power.
SS T-Coolant (EMU) Safety system detects excessive cool‐
ant temperature
Reduce power.
SS T-Lube Oil Safety system detects excessive lube-
oil temperature
Reduce power.
Stop Activated (EMU) EMU has tripped automatic stop com‐
mand due to limit value violation
1. Determine cause of shutdown and
rectify;
2. Note further alarms / indications on
display.
TD P-Lube Oil Different measurement values trans‐
mitted by the two sensors for lube-oil
pressure measurement
1. Check LOP visually (→ Page 154).
2. Perform LOP test procedures
(→ Page 156).
3. Check ECU plug-in connections
(→ Page 149).
4. Check engine wiring (→ Page 145).
5. Contact Service
• Have sensors checked and re‐
placed, if required.
TD T-Coolant Different measurement values trans‐
mitted by the two sensors for coolant
temperature measurement
1. Check LOP visually (→ Page 154).
2. Perform LOP test procedures
(→ Page 156).
3. Check ECU plug-in connections
(→ Page 149).
4. Check engine wiring (→ Page 145).
5. Contact Service
• Have sensors checked and re‐
placed, if required.
Trolling Active RCS measuring point Status message (signal lamp 'Trolling
Active' is ON)
Cylinder Cutout Measuring point "Cylinder Cutout" Status message of 'Cylinder cutout /
half of cylinders running' mode in idle
operation.
MW15407/14E 2012-02 | Troubleshooting | 75
TIM-ID: 0000008901 - 001
To Next Page
Loading...
