MI.NET MULTI-NETWORK COLLECTOR
25
Installation and Operation Manual
Tools Required (Figure A1-2):
• Tape measure
• Black marker
• Metal Snips
• ROBO-Grip
• Vise Grip
• Hammer
• Screwdriver (non-Phillips)
• 0.5" ratchet
• BAND-IT
®
C00169 Hand Tool
Procedure:
1. Cut two lengths of banding material. Length is 2X the pole
circumference plus ~ 9".
2. Bend a 0.6" piece of the banding material back on itself.
This keeps the buckle from sliding off of that end. Perform
this to both pieces of banding material, then add buckle &
brackets as shown in figure A1-3. Note that the left hand
side of each band has its end bent 180 degrees to keep the
buckles from sliding off.
3. Wrap a piece of rope / tape / acloth around the pole below
where the bands are going (optional). This prevents the
bands from sliding down the pole!
Figure A1-3: Band Preparation
Figure A1-2: Tools Required
To Next Page
Loading...