MI.NET MULTI-NETWORK COLLECTOR
26
Installation and Operation Manual
4. Wrap the top band around the pole & thru the buckle. Tighten the band (vise grips may be helpful here).
5. Wrap around the pole again, thru the bracket (may use fingers or
screwdriver to get band out of bracket) and the buckle
6. Using the vise grip, grab & tighten the band & then bend it back ~ 100
degrees so it will not further loosen. At this point, the band is double
wrapped, but movable.
7. Repeat for bottom band.
8. Both bands are now loosely attached to the pole.
9. Attach the collector to the brackets utilizing two bolts (the BAND-IT
brackets are threaded to hold the bolts). This is shown in Figure A1-6 &
A1-7 below.
Adjust the collector to its final location, then tighten the bands with the C00169
hand tool. The band may be held with the vice grips as the tool is attached (to
keep it from loosening too much).
Figure A1-4: Buckle & Bent Band
To Next Page
Loading...