MULTILIFT Ultima S Flex - Changing backlight settings (2 GCC)

161
Ultima S / SL Flex & Pro
3/2019
114060421
Hooklift Multilift Ultima S / SL Flex & Pro
Service Manual
Exit /
O 1
OK /
O 2
OK
1.
2,
3.
>>>
How to change the backlight setting of the buttons,
2GCC
The illumination strength of the backlight is set in the cab controller software. The buttons
to access the software and operations in the menu are as follows:
Note: The rst two buttons on
top of the cab controller are
the access buttons to the
software.
Normally these buttons are
identied as body locks
closed and body locks open.
The procedure of setting the illumination strength of the backlight is the following:
Press the rst row buttons simultaneously for 10
seconds.
“C002” can be seen in the display while pressing the
buttons.
System will make 2 short beeps and all red LEDs will
be shortly lit.
A text “tESt” is shown in the display.
Press the top button on right (locks open button).
Sub menu up
(fast speed)
Sub menu down
(hook safety lock)
Press
10 s