MULTILIFT Ultima S Flex - FAULT FINDING; MULTILIFT PLC - Diagnostic Codes

163
Ultima S / SL Flex & Pro
3/2019
114060421
Hooklift Multilift Ultima S / SL Flex & Pro
Service Manual
7.
8.
>>>
Exit
FAULT FINDING
MULTILIFT PLC - Diagnostic Codes
The diacnostic codes of Multilift PLC can be seen on the display of control unit and on the
service display.
Press the top left button (locks closed) to exit from the sub
level menu.
Text “tESt” will be shown.
Press both top buttons for 5 seconds to exit the software and
return back to normal operation.
The text “OFF” will be shown for a couple of seconds in the
display.
The backlight illumination will dim after 30 seconds of inactive period and light
up when joystick is moved or any button pressed.
If both “HI” and “LO” are set to same value, there is no di󰀨erence in the
brightness.
Press
5 s