MULTILIFT Ultima S Flex - Error codes (control unit)

164
Ultima S / SL Flex & Pro
3/2019
114060421
Hooklift Multilift Ultima S / SL Flex & Pro
Service Manual
There are 4 types of codes:
- Faults F000 - F081 explaining any faults in electronic and electric system
- Conicts C000 - C020 explaining any conicts during use
- Diagnoses d000 - d025 explaining any illogical operation
- error codes 01.01 -99.00 in the control unit.
Faults are most critical errors and these usually need more thorough examination on the
components or power feed. Usually there is a short circuit causing the error.
Conicts can be less critical and usually there is a missing signal from a switch causing
the error.
Diagnoses are usually caused by fault operation or missing signal from proximity switch.
If there are more than one error code in the system, the display in control unit is showing
them in sequence and should be read all before any corrective action is started. The
service display will show all errors in same screen.
The error codes will get o󰀨 after fault is corrected / repaired. All error codes are recorded
in a log le of the system memory and can be read afterwards with the service display.
Error codes
Faults Conicts Diagnoses in the control unit
F000 - F081 C000 - C020 d000 - d025 01.01 -99.00