MULTILIFT Ultima S Flex - Page 181

181
Ultima S / SL Flex & Pro
3/2019
114060421
Hooklift Multilift Ultima S / SL Flex & Pro
Service Manual
FAULTS
11.00
LOW ANALOG
INPUT ERROR
AT START-UP
JOYSTICK NOT IN
NEUTRAL POSITION.
ERROR DISPLAYED ON DISPLAY. JOYSTICK
FUNCTIONALITY WILL BE REMOVED UNTIL
NEXT POWER CYCLE.
12.00
LOW DIGITAL
INPUT ERROR
ERROR DETECTED ON
A SWITCH.
ERROR DISPLAYED ON DISPLAY. JOYSTICK
FUNCTIONALITY WILL BE REMOVED UNTIL
NEXT POWER CYCLE.
13.01
LOW ANALOG
INPUT
ERROR,
(JOYSTICK
FRONT
AND BACK
MOVEMENT)
ERROR DETECTED ON
JOYSTICK.
ERROR DISPLAYED ON DISPLAY. JOYSTICK
FUNCTIONALITY WILL BE REMOVED UNTIL
NEXT POWER CYCLE.
13.02
LOW ANALOG
INPUT
ERROR.
(JOYSTICK
LEFT TO
RIGHT
MOVEMENT)
ERROR DETECTED ON
JOYSTICK.
ERROR DISPLAYED ON DISPLAY. JOYSTICK
FUNCTIONALITY WILL BE REMOVED UNTIL
NEXT POWER CYCLE.
17.01
SEVERE LOW POWER
SUPPLY
LOW POWER SUPPLY
(BELOW 8,5 VDC).
ERROR DISPLAYED ON DISPLAY, SYSTEM
SWITCHED TO ERROR STATE. SYSTEM MUST
BE POWER CYCLED.
17.02
SEVERE HIGH POWER
SUPPLY
HIGH POWER SUPPLY
(ABOVE 36.0 VDC).
ERROR DISPLAYED ON DISPLAY, SYSTEM
SWITCHED TO ERROR STATE. SYSTEM MUST
BE POWER CYCLED.
18.01
SEVERE SAFE STATE
FAILURE
FAILED TO TAKE
SYSTEM TO
SAFESTATE.
ERROR DISPLAYED ON DISPLAY, SYSTEM
SWITCHED TO ERROR STATE. SYSTEM MUST
BE POWER CYCLED.
99.00
MEDIUM UNDEFINED
ERROR
UNDEFINED ERROR
IN CONTROLLER.
(SOFTWARE LOGIC IS
INCORRECT)
ERROR DISPLAYED ON DISPLAY, CAN
MODULE SWITCHED TO PRE-OPERATIONAL
STATE AND SYSTEM WILL SELF RESET
AUTOMATICALLY. WAIT, UNTIL THE SYSTEM
HAS STARTED.
ERROR
CODE
1.2 (CATEGORY)
DESCRIPTION CAUSE ACTION