38 Part Number 9294844 April 6, 2023
Maintenance Section 4
BLENDERS / DISPENSE AREA CLEANING & SANITIZING
Grate Removal / Blender Station Wash
n
Warning
The blender station contains sharp moving parts. Wear
gloves to protect hands.
Follow the on screen instructions:
• Put on gloves and safety glasses.*
1. Remove grate(s) from the blender station(s) while
being cautious of the blender blades.
2. To remove the grate pull it toward you then up and out.
3. Spray all surfaces inside of both blender stations
with cleaning solution , then scrub thoroughly with
approved cleaning brush.
4. Thoroughly wipe all surfaces of blender station with a
clean towel.
5. Repeat for other side if applicable.
• Press the Down Arrow. The Slide Progress screen
will display while the blender(s) move into cleaning
position.
Blender Door Removal
1. Slightly open blender door.
2. Squeeze at bottom of door.
3. Tilt out and pull the door down and out.
4. Repeat for other door if applicable.
• Press the Down Arrow to continue.
Blender Station Wash
1. Completely spray blender station with cleaning
solution. Use cleaning brush to thoroughly scrub down
the entire area.*
2. Using the approved cleaning brush, thoroughly scrub
down top of blender cap and blender arm.*
3. Lift blender cap and thoroughly scrub (with the
approved cleaning brush) top of blade housing and
bottom of blender cap.*
4. Thoroughly spray with sanitizer solution.
5. Using the approved cleaning brush, scrub entire
blender assembly.*
6. Repeat for other side if applicable.
• Press the Down Arrow to continue.
To Next Page
Loading...
