46 Part Number 9294844 April 6, 2023
Maintenance Section 4
SANITIZING ICE BIN OPTIONAL
*These steps will only display during the ZONE 2 Cleaning on
units with this feature turned on in the Managers Menu. If this
feature is not active, the interface will automatically proceed to
“Grate Removal / Blender Station Wash” on page 48.
NOTE: Ice Bin Sanitizing will add approximately 1 hour and
45 minutes to the Zone 2 Cleaning time.
Gather the Following Supplies
Cleaning Buckets - Set of Two (2)
Cleaning Hose*
(Located below product bins)
Ice Removal Chute
Splash Guard
Sanitizing Solution
Approved sanitizers:
Solution that provides 100 ppm available
chlorine minimum.
Or solution providing 300 ppm Quaternary
Ammonium minimum.
Or sanitizer part number 9405653, use 3.25
oz/5 gal (96 ml/19L).
Cleaning Brush, Gloves & Safety Glasses*
* These items are optional and may not be displayed on all easyToUCH
screens.
NOTE: If other cleaners are used, it is possible they will not
clean or sanitize your machine to NSF standards.
• Press the Down Arrow to continue.
Removal of Ice
Follow the on screen instructions:
1. Install ice removal chute in dispenser area.
2. Place empty bucket on floor under ice chute.
3. Press the Green Check to begin dispensing ice.
• The Ice Dispensing Timer screen will display, and the
machine will empty of ice.
Ice Disposal
1. Dispose of ice in the bucket and set aside.
2. Remove ice removal chute from the dispenser area and
set aside.
3. Press the Green Check.
To Next Page
Loading...
