EasyManua.ls Logo

Multiplex WELBILT Blend-In-Cup MB-8-1PP6 - Ice Maker;Bin Descaling, Cleaning, Sanitizing Prep; Ice Disposal After Descaling

Multiplex WELBILT Blend-In-Cup MB-8-1PP6
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Part Number 9294844 April 6, 2023 61
Section 4 Maintenance
ICE MAKER / BIN DESCALING, CLEANING & SANITIZING
Removal of Ice
Follow the on screen instructions:
1. Install ice removal chute in dispenser area.
2. Place empty bucket on floor under ice chute.
3. Press the Green Check to begin dispensing ice.
The Ice Dispensing Timer screen will display, and the
machine will empty of ice.
Ice Disposal
1. Dispose of ice in the bucket and set aside.
2. Remove ice removal chute from the dispenser area and
set aside.
3. Press the Green Check.
Descaling Ice & Water System Prep
Important
These steps will only display if descaling has been turned
on in the Managers Menu. If this feature is not active,
the interface will automatically proceed to “Sanitizing
Ice Maker Prep on page 62.
1. Put on gloves and safety glasses.*
1. Install splash guard in the dispense area.
2. Fill sanitizer bucket with water and add descaler.
NOTE: Use an approved ice machine cleaner. Consult
manufacturers instructions for correct ratio.
3. Route cleaning hose from cabinet to the outside of unit.
4. Place cleaning hose into bucket with descaler solution.
5. Press the green check to begin descaling the ice machine.
The Descaling Ice Maker Timer Screen will display
and count down during the descaling process.
Continue Descaling Screen will display once
completed.

Table of Contents

Related product manuals