48 Part Number 9294844 April 6, 2023
Maintenance Section 4
Grate Removal / Blender Station Wash
n
Warning
The blender station contains sharp moving parts. Wear
gloves to protect hands.
Follow the on screen instructions:
• Put on gloves and safety glasses.*
1. Remove splash guard from dispense area.
2. Remove grate(s) from the blender station(s) while
being cautious of the blender blades.
3. To remove the grate pull it toward you then up and out.
4. Spray all surfaces inside of both blender stations with
cleaning solution and scrub thoroughly with approved
cleaning brush.
5. Thoroughly wipe all surfaces of blender station with a
clean towel.
6. Repeat for other side if applicable.
• Press the Down Arrow. The Slide Progress screen
will display while the blender(s) move into cleaning
position.
Blender Door Removal
1. Slightly open blender door.
2. Squeeze at bottom of door.
3. Tilt out and pull the door down and out.
4. Repeat for other door if applicable.
• Press the Down Arrow to continue.
Blender Station Wash
1. Completely spray blender station with cleaning
solution, use cleaning brush to thoroughly scrub down
the entire area.
2. Using the approved cleaning brush, thoroughly scrub
down top of blender cap and arm.
3. Lift blender cap and thoroughly scrub top of blade
housing and bottom of blender cap.
4. Repeat on other side if applicable.
• Press the Down Arrow to continue.
To Next Page
Loading...
