Part Number 9294844 April 6, 2023 49
Section 4 Maintenance
Clean Blender Shaft Bushing *
NOTE: Some units do not have a blender shaft bushing.
1. Follow the blender shaft up above the blender cap, use
fingers to pull the bushing out of the blender chamber.
2. Spray with cleaner and use a brush and/or clean cloth.
3. Spray with sanitizer and push back up into place.
4. Thoroughly spray with sanitizer solution and using a
cleaning cloth wipe entire blender assembly.
5. Repeat on other side if applicable.
• Press the Down Arrow when completed.
Wash Blender Grate(s) / Door(s)
1. Take all grates, cup cover seals, and doors to sink to wash
and sanitize.
2. Do not put in dishwasher or power soaker.
n
Warning
When in contact with cleaning and sanitizing solution
chemicals gloves and safety glasses are recommended.
• Press the Down Arrow when completed.
Reinstall Blender Door(s)
1. Reinstall blender door(s).
• Press the Down Arrow. The Slide Progress screen will display
and the blender(s) will move into operating position.
Reinstall Blender Grate(s)
1. Reinstall blender grate(s).
• Press the Down Arrow to continue.
To Next Page
Loading...
