Part Number 9294844 April 6, 2023 45
Section 4 Maintenance
Purging Lines
1. Disconnect the cleaning hoses from the white nozzles.
2. At each white nozzle remove cleaning manifold tube
and spray with sanitizer, then reinstall each cleaning
manifold tube. Spray sanitizer on all surfaces inside the
refrigerator.
3. Press Green Check to continue and purge the lines. Air
is pushed through each line blowing out any remaining
liquid. The line on the display will change from
Sanitized to Purged and turn green.
NOTE: Air is pushed through each line (slot) blowing out
any remaining liquid, displaying the progress on the screen,
30 seconds per slot. When purging has completed the
Reinstall Inventory Screen will appear automatically.
Reinstall Inventory
1. Retrieve product holders from refrigerated storage and
reinstall each into their correct slot number.
2. Remove splash shield and reinstall center grate into the
dispense area.
3. Place a large empty cup under the dispensing nozzles.
4. Press the down arrow, then press the Green Check
when ready to prime all product slots.
NOTE: This will automatically prime each line with product.
The screen will read Priming Slot X. Each slot will change
from Purged to Primed. When priming has completed the
Prime Completion Screen will appear automatically.
Auto Prime Complete
1. Remove and dispose of large cup with primed product.
Important
Do Not pour down the drain on the BIC unit!
2. Press the Green Check to continue to the Sanitizing Ice
Bin & Water Nozzles screen. If this feature is not turned
on in the Managers Menu, proceed to “Grate Removal /
Blender Station Wash” on page 48.
3
1
2
3
4
5
6
7
8
To Next Page
Loading...
