PAGE 36 — WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20)
ENGINE TUNE-UP
See your engine manual for specific information on tuning up
your engine, checking and gapping the spark plugs, etc.
ADDING HYDRAULIC OIL
1. Check the hydraulic oil level in the hydraulic oil tank
by reading the hydraulic oil sight glass (Figure 36)
mounted on the hydraulic oil tank.
Figure 36. Hydraulic Oil Sight Glass
2. If the hydraulic oil level is low, fill to the proper level with
EXXON/MOBIL NUTO H68 or equivalent.
3. To gain access to the hydraulic oil tank filler hole, the
tub (Figure 37) must be placed in the dump (vertical)
position.
4. Start the engine as outlined in the starting procedure,
then place the tub in the dumping position.
NOTICE
See the engine manual supplied with your machine
for an appropriate engine maintenance schedule and
a troubleshooting guide for problems.
NORMAL
OPERATING
LEVEL
Figure 37. Tub Dump Position
Hydraulic Oil Access
5. Use the tub support rod to support the tub, then turn
the engine OFF.
6. Remove the two bolts that secure the access cover
(Figure 38) to the buggy frame.
Figure 38. Access Cover
7. Lift up on the access door and secure the latch
(Figure 38).
TUB
(BUCKET)
WTB16
LEVER
SUPPORT
ROD
REMOVE BOLTS (2)
ACCESS
COVER
LATCH
MAINTENANCE
To order go to Discount-Equipment.com
To Next Page
Loading...
