WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20) — PAGE 37
8. Remove the hydraulic oil filler cap (Figure 39) and add
hydraulic oil as required. Fill to the normal operating
mark as indicated on the hydraulic oil sight gauge.
Figure 39. Adding Hydraulic Oil
9. Replace hydraulic oil after every 500 hours of operation.
The reservoir capacity is 5.3 gallons (20.4 liters). The
hydraulic oil filter should be changed each time the
hydraulic oil is changed.
HYDRAULIC
FLUID
HYDRAULIC TANK
FILLER NECK
NOTICE
In climates where temperatures are below 35°F (1.6°C),
hard starting may occur. In these cases, the hydraulic oil
should be switched to a thinner 15weight hydraulic fluid.
HYDRAULIC OIL FILTER REPLACEMENT
1. Replace the hydraulic oil filter (Figure 40A) every 500
hours. Replace with only the recommended type filter.
Figure 40. Hydraulic Oil Filter
2. Using an oil filter wrench (Figure 40A), remove the
hydraulic oil filter.
3. Clean the area around the lubricating hydraulic oil
filter head.
4. Coat the rubber seal (gasket) surface of the oil
filter (Figure 40B) with clean 15W-40 engine oil.
5. Install the new hydraulic oil filter first by hand until it
makes contact with the filter head surface. Tighten it
another 3/4 turn using the filter wrench.
6. Run the system and check for leaks.
HYDRAULIC
OIL FILTER
COAT RUBBER
SEAL WITH THIN
LAYER OF OIL
INSTALL
NEW HYDRAULIC
OIL FILTER
REMOVE AND
DISCARD FILTER
FILTER
WRENCH
A
B
MAINTENANCE
To order go to Discount-Equipment.com
To Next Page
Loading...
