MULTIQUIP WTB-16PD - Page 38

PAGE 38 — WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20)
MAINTENANCE
HYDRAULIC DRIVE MOTORS
The hydraulic drive motors (Figure 41) are extremely
reliable and will not need maintenance or repair under
normal conditions.
Figure 41. Hydraulic Drive Motor
CHASSIS LUBRICATION
This power buggy is equipped with six Zerk fittings
(Figure 42). Lubricate these Zerk fittings each day before
operating the buggy.
1. Lubricate with high-grade chassis lubricant at all
lubricating points listed below:
• Tub Bearing Pivot Blocks (Underside of Tub) — Two
Zerk fittings on both sides of the machine (Figure 42A).
• Dump Cylinder Pivots — Two Zerk fittings, top and
bottom of dump cylinder (Figure 42B).
• Swivel Wheels — Two Zerk fittings, both sides of
machine (Figure 42C).
HYDRAULIC DRIVE MOTOR
LEFT
HYDRAULIC
DRIVE MOTOR
RIGHT
HYDRAULIC
DRIVE MOTOR
NOTICE
Contact Multiquip’s Service Department should any
problems develop with the hydraulic drive motors.
Figure 42. Lubrication Points
GREASE
GUN
ZERK FITTING
TUB
BEARING
PIVOT
BLOCK
DUMP
CYLINDER
A
B
DUMP
CYLINDER
(TOP)
DUMP
CYLINDER
(BOTTOM)
SWIVEL
WHEELS
GREASE
GUN
GREASE
GUN
C
To order go to Discount-Equipment.com