Multitech MultiConnect Dragonfly MTQ-MNG6-B02 - Testing Cellular Data; Activating a PDP Context; Conducting a Ping Test; Configuring Low Power Options

GETTING STARTED
26 MultiConnect
®
Dragonfly
TM
MTQ-MNG6-B02 Device Guide
+CREG: 0,1
OK
AT+CEREG?
+CEREG: 0,1
OK
AT+CGREG?
+CGREG: 0,1
OK
Testing Cellular Data
Once the device is configured and registered with the cellular network, activate a PDP context and conduct a ping
test to ensure the device is sending and receiving data.
Activating a PDP Context
Before sending data, activate a carrier specific PDP context with the following.
AT#SGACT=1,1
Example
AT#SGACT=1,1
#SGACT: 100.72.154.34,38.0.16.20.176.134.63.233.0.0.0.0.187.242.184.1
OK
Conducting a Ping Test
After activating the PDP context, use AT#PING to verify network connectivity.
AT#PING="<Domain or IP Address>"
Example:
AT#PING="8.8.8.8"
#PING: 01,"8.8.8.8",0,114
#PING: 02,"8.8.8.8",0,114
#PING: 03,"8.8.8.8",1,114
#PING: 04_Cel,"8.8.8.8",2,114
OK
Configuring Low Power Options
Refer to Powering Down the Device for lowest power consumption.
To configure PSM:
AT+CPSMS
To configure eDRX: