Start-up
Setting up the machine and putting it into operation
36 11.06.2014
¾ Unscrew the screw plug. To do so, turn the screw plug anti-
clockwise.
¾ Only fill in so much oil until there is a small air bubble at the top
in the oil sight glass.
¾ Screw the screw plug tightly in the drain opening. To do so,
turn the screw plug clockwise.
¾ Wipe off and remove any oil from the machine.
¾ Check the oil level on the oil sight glass.
¾ Turn the screw plug in the fill opening and screw it tight. Turn the
screw plug clockwise.
To Next Page
Loading...
