Start-up
Setting up the machine and putting it into operation
11.06.2014 37
¾ Wipe off any spilt oil
¾ Close the housing. Ensure that there are no cables between the
housing and the base plate.
¾ Tighten the two screws which attach the housing. Turn these
screws clockwise.
– The housing is closed and tight.
¾ Check the mains voltage on the type plate and compare it with the
voltage of the mains electricity.
¾ If the values match, connect the machine to the mains electricity
at a place which is always easily accessible.
To Next Page
Loading...
