Start-up
Setting up the machine and starting it up
40 11.06.2014
¾ Attach the gas hose to the inert gas connection of the machine.
¾ Fasten the hose with hose clamps.
¾ Open the stop-cock for the gas supply.
¾ Set the input pressure; see Technical Specifications.
¾ Check the mains voltage on the type plate and compare it with the
voltage of the mains electricity.
¾ If the values match, connect the machine to the mains electricity
at a place which is always easily accessible.
¾ Remove all the protective film.
¾ Clean the machine, see Section 6 "CLEANING"
To Next Page
Loading...
