multivac P300 - Install the Sealing Bar; Repair Counter-Pressure Bar

Maintenance
Replace the sealing ba
r
11.06.2014 63
¾ Pull out the sealing bar.
7.3.2 Install the sealing bar
¾ Disconnect the machine from the mains electricity.
¾ Open the chamber lid. Open the chamber lid more than half way
so that it remains open.
– The chamber lid remains open in the middle position.
¾ Install the sealing bar on the carriers.
– The screws on the sealing bar should point to the middle of the
chamber.
7.4 Repair counter-pressure bar
¾ Open the chamber lid. Open the chamber lid more than half way
so that it remains open.
– The chamber lid remains open in the middle position.