To Next PageTo Next PageWhat to do if my Munsch NPC Water Pump motor is running on 2 phases?
If your Munsch Water Pump motor is running on 2 phases, check the fuse and replace it if necessary. Also, check the cable connections and insulation.
What to do if Munsch Water Pump is distorted?
If your Munsch Water Pump is distorted, check the pipe connections and pump fixation. Check the coupling alignment and the support foot fixation.
What to do if coupling packets worn in Munsch NPC?
If the coupling packets in your Munsch Water Pump are worn, replace the coupling packets and realign.
What to do if the casing seal of Munsch NPC is defective?
If the casing seal of your Munsch Water Pump is defective, replace the casing seal.
General| Drive | Electric motor |
|---|---|
| Sealing | Mechanical seal |
| Power Source | Electric |
| Type | Centrifugal Pump |
| Horsepower | 1 to 500 HP |
| Port Size | 1 to 12 inches |
Specifies the correct and intended use of the pump and its limitations.
Provides general safety rules to follow before performing any work on the pump.
Outlines the responsibilities of the operating company for safe pump management.
Defines the duties of personnel operating and maintaining the pump safely.
Highlights specific hazards associated with the pump's operation.
Details the process of setting up the pump on a foundation.
Details the procedure for mounting the motor onto the pump unit.
Covers the electrical connection of the motor, emphasizing safety.
Provides detailed steps for accurately aligning the pump and motor couplings.
Details how to align the motor using shims to achieve proper coupling alignment.
Provides detailed steps for safely starting up the pump and checking its operation.
Covers maintenance of roller bearings and stationary seal rings.
Provides detailed instructions and safety precautions for disassembling the pump.
Provides guidance on reassembling the pump after disassembly.
Provides causes and remedies for various pump operational disturbances.
