Munsch NPC Series - Page 3

Table of contents
7.4.1 Preparations for assembling . .. . . . . . . .. . . . . . 30
7.4.2 Fitting the pump shaft ........................ 30
7.4.3 Fitting the bearing bracket . .. . . . . . . .. . . . . . . .. 30
7.4.4 Fitting the casing cover .. . . . . .. . . . . . . .. . . . . . . 30
7.4.5 Fitting the pump into the installation . .. . . . . . 30
7.5 Ordering replacement parts ................. 30
8 Disturbance recovery .............................. 31
9 Appendix ............................................. 34
9.1 Sectional drawings ........................... 34
9.1.1 Part numbers and designations ............. 34
9.1.2 Overview sectional drawing . .. . . . . . . .. . . . . . . 36
9.1.3 Variants ....................................... 36
9.2 Technical specifications ...................... 40
9.2.1 Ambient conditions ........................... 40
9.2.2 Parameters for auxiliary operating
systems ....................................... 40
9.2.3 Noise pressure level . . . .. . . . . . .. . . . . . . .. . . . . . 40
9.2.4 Tightening torques ........................... 41
9.2.5 Lubricants .. . . . . . .. . . . . . . .. . . . . . .. . . . . . . .. . . . . . 42
9.2.6 Detergents .................................... 42
9.2.7 Socket loads according to ISO 5199 . . .. . . . 42
9.3 Replacement parts for 2 years of continuous
operation according to DIN 24296 . . .. . . . . .. 43
EN – 02 BA-2005.07 NPC series 3